How to service the car

How to service the car

Like any other thing, the car needs care. This will extend the car’s life, and timely inspection and proper care will save a decent amount of money. In addition, repair during the operation of a vehicle is inevitable; these two things are inherently related to each other. Thus, you can make car service visits rarer if you treat your “wheel friend” more reverently.

Serve your “iron horse.”

Serious breakdowns and routine inspections must be done services or representative offices. However, there are some procedures that a motorist can do on their own. Such preventive measures should be taken depending on the behavior of the car.

The main points are checking the tyre pressure and the level of technical fluids. If a deficiency of one or the other is established, then it should be filled. Smart cars are adorned with exceptional sensors that notify the driver of a lack of fluid. These sensitive sensors greatly facilitate the maintenance of the machine.

  1. Checking the oil level

The regular running of the car’s power unit directly depends on the oil. If the car enthusiast has neglected this moment for some time, the engine power will significantly decrease. The car owner should check the oil level once a month; if the car is operated daily and a lot, the systematic check should be increased. The motorist should turn off the engine and let it cool before investigating.

Before advancing with the inspection, certain requirements must be met:

  • Put the car on a flat horizontal surface.
  • Thoroughly wipe the test probe.
  • Insert it to the very end and remove it.

There is a unique mark on the dipstick that shows the optimal level of technical fluid.

The oil must be topped up; it is vital to ensure that it is the same type. It is necessary to add technical fluid only when the engine is turned off and cooled. The machine must be given a little more time for the oil to flow from there into a special tray. You can use a funnel to add oil. It is important not to overfill; this can affect the engine’s operation and, moreover, for the worse. It is also undesirable to spray oils on the sides.

  1. Coolant level

It is imperative to monitor the coolant level; if the dipstick shows its deficiency, it must be replenished as soon as possible. Topping up coolant, as in oil, should only be topped up when the power unit has cooled down. Impatient motorists’ risk serious harm to their own health due to a splash of boiling technical fluid. If the liquid level drops sharply immediately after refilling, this indicates the presence of leaks. In such a situation, a specialist intervention will be required.

  1. The level of technical fluid in the gearbox

Before this procedure, the car should be fixed on a flat horizontal surface; for this, you need to use the “handbrake”. The operation should be carried out with the engine running; it is crucial to monitor the temperature of the liquid. It should be normal. Since the surface of the power unit is very hot, it is important to observe safety measures and be extremely careful.

The engine must be idling, then the gear lever must be shifted to all positions, observing the sequence. This must be done from position P to D and back. Having done these simple steps, you should go to the next step: the pre-wiped dipstick should be immersed in the gearbox, opening to the maximum. The oil level must not be below the “HOT” mark. Otherwise, it is necessary to top up the technical fluid to the required level.

In addition to changing the technical fluid, you need to pay attention to the following points about once a week:

  • the condition of the tyres their wear and air pressure.
  • Ensure that you have a spare tyre in your trunk. Bonus points for you if they’re from a well-known car tyre company.
  • wiper blades.
  • the battery the condition of the tray of this component and the connection and integrity of the contacts.
  • Car electrical equipment should also be given attention. Check the horn, harnesses and contacts, and parts that connect the electrical wiring weekly.

Powertrain service

Lack of maintenance will affect the operation of the motor; this will certainly appear if the car is purchased already used. The costs in this situation are inevitable, but they will pay off.

Engine wear, if suspected, can be determined by applying compression. With its help, the driver will be able to imagine the scope of future repairs. Maintenance will not help if the damage and wear to the motor are severe. So, what to do to improve the performance of the power unit and extend its life:

  • the battery should be cleaned and checked.
  • Checking the condition of technical fluids, all.
  • Condition and tension of belts on belt drives. If required, replace one of them.
  • Spark plugs also need a systematic check.
  • you need to pay attention to all components of the ignition system.
  • the air filter must be in good working order. Otherwise, it must be replaced with a suitable one.

Car maintenance and the frequency of its repair are directly related to procedures. Therefore, if you pay all your attention to the first, you will not have to repair your car often, and you will not have to invest a lot of money in this procedure. Why My car won’t start | Reason and how to fix it


Leave a Reply

Your email address will not be published. Required fields are marked *